Just squeeze the shit out of it and make sure you have a literal deathgrip on it. You could also try a rubber band which may help with gripping the stripped screw. Take your screwdriver and a hammer and place the screwdriver into the stripped screw and tap on it just enough to make new indentations.
This DIY PS4 repair video shows users how to remove a disc that is stuck in a PS4 game console. Playstation 4's all have manual eject screws. Many people thiTake a USB stick and format that as FAT32. Created a directory called PS3 and then a directory in there called UPDATE. Throw the downloaded patch in that directory which will now allow you to update teh PS3 without downloading the file from the internet. Thats the good news. On the bad side, you have to take the drive out of your PS3 and format Plug the console in, and turn it on. The gears should start spinning. If they do not, press the eject button. If that checks out, place the top half of the blu-ray drive back on the drive, and try inserting a disk. If it goes in, your good to go. If it makes a horrible crunching sound, you will have to go and try again. 2 Easy ways how to remove Eject Stuck Games, DVD, BLURAY, CD, disc, disks from in PS3, Top best ways how to remove force ejecting DVDs, games, blurays, CDs, The console didn't have a disc stuck in it when I bought it, but it wasn't reading the disc I put in and was having trouble accepting and ejecting discs, as if it wasn't gripping the discs hard enough or not pulling/pushing with enough power. I took it apart, cleaned it, and put it back together. If it "makes a bad noise" and reads some discs it's definitely not a pairing problem either, but of mechanicals. If you replace the drive's board (which as said only applies to 2100 series and older) you must remarry afterwards to be able to use the drive as a drive. Reactions: naxil and MrCokeacola. Please follow steps below: Step 1: Shut down the PS3 and then start it up by pressing and holding the power button for 10 seconds until you hear three beeps. It will shut again, at which point, repeat the process until you hear a quick double-beep and see the Safe Mode screen appear. .